People replace the hose because the one in the box is short, stiff, or both. The replacement still has to survive the pump. A hose rated under the washer’s maximum PSI is not a bargain.
The three numbers on the tag
Working pressure at 70°F is the rating that has to clear your machine. Flexzilla’s own chart lists 3,100 PSI for the HFZPW3450M and 4,000 PSI for the HFZPW40550M. Retail listings for the HFZPW426050Q list 4,200 PSI. Put the hose next to your washer’s maximum, not next to the pressure you “usually” use. A 0° tip and a stuck unloader can show the system the maximum.
Inside diameter is 1/4, 5/16, or 3/8 inch on these three. Narrower is lighter and loses more performance over 50 feet. The 3/8-inch hose is the one that makes sense on a 4 GPM pump, and it is also the one with quick-connect ends.
Length is 50 feet on all three parts listed here. That is the length that lets you leave the washer in one spot for a car and a sidewalk. Coil it without a kink. A kink left under pressure is how jackets split.
Fittings and care
Hand-tighten M22 nuts. If they weep, check the o-ring before you add pliers. Replace a hose with a cut jacket, a bubble, or a fitting that spins in the crimp. Do not run a car over it and then trust it.
These are cold-water hoses. Drain them before a freeze. A hose full of ice is done, and so is the afternoon you planned.
The weakest link still rules. A 4,000 PSI hose does not make a 3,600 PSI wand acceptable on a 4,200 PSI washer. Every part in the chain has to clear the machine. The nozzle and wand guide is the other half of that check.