The useful question is not which kind is better. It is which limit you will hit first: the cord, the flow, or the noise you are willing to make on a Saturday.
Choose electric when the work is close
An electric washer plugs into a 120-volt outlet and draws 13 to 14.5 amps on the machines in the electric guide. You get no fuel, no oil changes, and a machine you can lift or roll without a truck. The Greenworks, Sun Joe, Westinghouse, Ryobi, DeWalt, and Kärcher models on that page are all cold-water tools with a ceiling around 104°F at the inlet.
They fit cars, grills, plastic furniture, a small wood deck if you stay gentle, and a short concrete pad if you are patient. The Kärcher K1700 Cube is the shelf unit. The Greenworks GPW2300 is the one with more published flow.
The cord is the real specification. Thirty-five feet of factory cord plus a 20- or 25-foot hose is the bubble you can clean. Outside that bubble you are either moving the washer constantly or running a long extension cord the manual may not allow. Voltage drop cooks motors. If the outlet is on the wrong side of the house, stop arguing with the cord and look at gas.
Choose gas when the work is concrete or far away
The gas guide is 2.4 GPM and up. That is the difference you feel on a driveway, because a surface cleaner wants water, not a slogan. The Westinghouse WPX3400 and the Simpson PS3228 are the homeowner pair. The Generac is the lighter cart. The DeWalt DXPW4240 is a 4 GPM contractor machine with a 5 GPM water-supply requirement written in the manual.
Gas means exhaust, so it stays outdoors and away from open windows. It means oil before the first start, and a winterizing step before a freeze. Two of the machines on the gas page are poor fits for California because of emissions listings. Read that before you fall in love with a model number.
Noise is the neighbor problem. Electric is not quiet, but gas is a small engine for as long as the job lasts. If you are in a tight lot and the job is a car, take the electric and finish before anyone cares.
A straight comparison
| Electric | Gas | |
|---|---|---|
| Typical flow here | About 1.1–1.8 GPM | About 2.4–4.0 GPM |
| Setup | Plug into a 15-amp GFCI | Fuel, oil, choke, outdoors |
| Storage | Shelf to a small cart | Cart, fuel, exhaust path |
| Best job | Cars, furniture, small decks | Driveways, distance, repeat flatwork |
| Ongoing care | Don’t freeze the pump | Oil, pump saver, fuel storage |
PSI is a poor tie-breaker. Sun Joe’s own manual puts the SPX3000 at 2,030 PSI maximum and 1,450 PSI once it is working. A gas washer’s single published number is often the figure the marketing uses. Read both, then buy for the surface. The PSI and GPM guide is the short version of that habit.
What not to buy around
Do not buy a gas washer to wash one car a month. You will dread starting it, and an electric will do the car with less ceremony. Do not buy an electric to strip a long stained driveway because a video said 2,300 PSI was plenty. The video did not show the hour you will spend on 1.2 gallons a minute.
If you are pricing tools because you might wash other people’s concrete, read the side business guide before the cart gets bigger than the work.